robert0762 Posted February 14, 2013 Report Posted February 14, 2013 I have a set of 39 PWK's from a snow mobile . They have a number 6 slide in them right now . Is this the same slide that is in them when set up for a banshee or do I need different slides ? Also the fuel inlet is on a 90 deg. angle . Where can I find a straight one to replace these ? I need a straight one Quote
KozyHeat Posted February 15, 2013 Report Posted February 15, 2013 If you are skilled - cut the fitting off, drill the top out, braze the hole shut, and braze fitting onto the top Free fix if you know somebody or have the equipment. Quote
Larry's Shee Posted February 15, 2013 Report Posted February 15, 2013 Try Carb Parts Warehouse or Sudco. Might also check the float needle, IIRC sleds are different due to fuel pump Quote
sprinklerman Posted February 15, 2013 Report Posted February 15, 2013 bet those are pumper carbs... Quote
KozyHeat Posted February 15, 2013 Report Posted February 15, 2013 ^ Put a bigger float needle for gravity fed. Pumper carburetor needles are small. So get compatible needle and seat. while your at it. Quote
robert0762 Posted February 16, 2013 Author Report Posted February 16, 2013 Still need some info on slide # 1 Quote
possum Posted February 16, 2013 Report Posted February 16, 2013 #6 is fine. I usually have #6 or #7 slides Quote
dave5.0 Posted February 16, 2013 Report Posted February 16, 2013 Aren't the passages inside the carb and air vents smaller too? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.