keihin pwk identification

[bansheefromhell]

I was needing to know what size my carbs are the number on the side just above the bowl is "S55AZ NDN" I've looked at keihin's website with no luck and emailed them a week ago with no response. I'm needing to buy new carb boots and need to know what size to get.

[lms1977]

either post up some pics of it , or measure the part where it would go into the carb boot then you would know what size boot you need

[Vicstuff]

^ that or look on jetsrus.com and find the pwk's and match your numbers

[2strokes4u]

Never seen that marking. I see S66, S63, S65, S46...but no S55.

[Dicklez]

Get a set of veneer's and measure

[bansheefromhell]

[bansheefromhell]

Never seen that marking. I see S66, S63, S65, S46...but no S55.

 

it might be 65, it's hard to tell

[sprinklerman]

if it says S65, its a 35 A/Stryker. Does it have "fins" on the intake side of the carb?

[bansheefromhell]

so you still haven't measured it?

 

it kind of hard when you work 7-7

[bansheefromhell]

 

it kind of hard when you work 7-7

 

this is the best photo I have right now

 

[lms1977]

thats a air stryker

[bansheefromhell]

 

 

Says PWK on the side. I also see power jets it looks like. You running methanol? Sorry I can't help you out on the size, easiest way might be to get a digital (or non) ID measure tool.

 

no but it is set up to run it

[sprinklerman]

if its truly "setup" for alky,then they wont work on gas. The dump tube will be drilled out too big for gas.

[n2otoofast4u]

Clueless

[bansheefromhell]

if its truly "setup" for alky,then they wont work on gas. The dump tube will be drilled out too big for gas.

 

I have no clue on how the alky set up works but I thought that's what the power jets where for, one of the cylinders has a hole drilled in it to pull vacuum for the fuel pump too. anyway I'm sure I'm wrong I'm a mechanic but never fucked with alcohol stuff