Shee keeps blowin headgaskets

[06bansheeboi]

Sick of my banshee blowing head gaskets, should I ditch the stock milled cylinder head for a noss cool head? Or is it a waste of time?

[toytech]

Sick of my banshee blowing head gaskets, should I ditch the stock milled cylinder head for a noss cool head? Or is it a waste of time?

 

if the head is junk, get a coolhead, noss, chariot, prodesign. all good. all use same domes.

 

and check to make sure your cyl decks are flat and even.

[06bansheeboi]

if the head is junk, get a coolhead, noss, chariot, prodesign. all good. all use same domes.

 

and check to make sure your cyl decks are flat and even.

 

 

 

 

 

 

Whats the best way to do that? mechanics straight edge

[lms1977]

Whats the best way to do that? mechanics straight edge

 

That would probably be a good way to check, is it always leaking or blowing at the same spot?

[06bansheeboi]

That would probably be a good way to check, is it always leaking or blowing at the same spot?

 

 

 

 

cant tell where its leaking but it last about a month, then out of nowhere it spits coolant out to a certain poiint. Then after that it starts putting out compression bubbles in my over flow. Bike doesnt run lean. and still runs good threw this problem

[BUILDER]

Once you blow a head gasket on a stock head you are going to play hell keeping a gasket in it unless you have the head trued! Stock heads do not hold up well after they blow a gasket once. If it keeps blowing it then your head is not flat any more and that is why it is doing it.

[BigRed350x]

Call up kevin at HJR and get a cool head and domes! He has them in-stock and ships fast!

 

-jared

[06bansheeboi]

Call up kevin at HJR and get a cool head and domes! He has them in-stock and ships fast!

 

-jared

 

just spoke with kevin at hjr, hes shipping my noss head out tomorrow thanks guys....