Gaaaah!

[01yamban]

After I was all fired up about finally getting this banshee running perfect yesterday... I went out to start it today and I can get it to kick over! It's got spark, new plugs, tried to adjust the air screw Its out 1.5 now, I know it will start with a rolling start because just by myself I can push it in my garage and second or third gear and get it to almost catch. yesterday when I finally got it started it ran great, after I got it warmed up i shut it down and it started first kick drove around a little more shut it down and a starter first kick again left it overnight and now I can't get it to start no matter how many kicks it almost caught a couple times but that's it WTF? One thing I know is when I let it sit and have the gas on the gas will drip out the overflow tubes from the bottom of the bowls does this have anything to do with it starting hard?

[Larry's Shee]

have you shut the gas off yet?

 

Ya got it flooded good. Can try new plugs, or let it sit with plugs out for a while to evap excess, even blow air down plug hole.

[ClayAiken]

Yeah Larry's Shee is right but mine for instance had a problem with the float valve that keeps the float around half way so it drips out of overflow. That doesnt effect how mine runs at all.

[01yamban]

Update: still wouldent kick over after sitting for 2 hours so I pushed to the top of my driveway let it roll down and jumped it in second, started instantly and ran like a effin champ, so idk what up with kicking it over

[Dicklez]

Check your compression