ECshee Posted April 30, 2011 Report Posted April 30, 2011 Side by side the stock 26mm mikuni carb for a banshee and blaster are primarily the same. My question is, if i put a vaccuum cap on the choke tube side, could i use this on my blaster? It already has the idle screw and cap for the TORS delete installed, unlike my blaster. So to save myself a few bucks i figured id give it a shot, in theory i guess it makes sense and would work....in my head. I could be wrong. Let me know! Quote
Larry's Shee Posted May 1, 2011 Report Posted May 1, 2011 Ya if you used side with choke knob. If you used right hand carb might be rough starting Quote
ECshee Posted May 1, 2011 Author Report Posted May 1, 2011 I did use the left-side carb, if you were sitting on the bike. The fuel line will connect, the vent tubes have been re-tubed, and the choke tube has been vacuum capped off. If it works the way i want it to, it would save me roughly $40 for the TORS delete kit, and instead i can buy new clutch and throttle cables. I dont know if the choke tube being capped off would create any negative space in the carb that could cause it to drag/ lag. Sounding and looking like i might try it though... Quote
Larry's Shee Posted May 2, 2011 Report Posted May 2, 2011 I would use a good adheasive like three bond on the vac cap tho. Thought about the same thing on Larry's blasturd, but only had a good right carb, didn't want to suck or blow on a tube while trying to start it Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.