SuperMex Posted February 24, 2011 Report Posted February 24, 2011 So just put on a set of +2 Roll Design A-Arms and noticed my rims hit when I turn to sharp is the fix just to flip the rims so there offset ? Quote
Larry's Shee Posted February 24, 2011 Report Posted February 24, 2011 Presuming toe is good look at the stops on the frame , they do get worn. Quote
Starwriter Posted February 24, 2011 Report Posted February 24, 2011 The steering stop on the frame is probably bent forward. Take a chunk of shaft and a big hammer and whack it rearward. The sides of it may be mushed. Weld it up, and then reinforce it. The steering shaft tab is rounded and pushes the frame tab forward, when the bikes been flipped a few times. Quote
SuperMex Posted February 24, 2011 Author Report Posted February 24, 2011 (edited) First thing I checked was my steering stop on frame its fine and its the stock rims so ill put my razors on today and see if I have problems with those as well. Oh and its not toed in at all I think its just the offset of the stock rims. Edited February 24, 2011 by ChuyVargas Quote
SuperMex Posted February 24, 2011 Author Report Posted February 24, 2011 just dont turn that sharp! Why didn't I think about that duhhhh hahahaha Quote
camatv Posted March 8, 2011 Report Posted March 8, 2011 i know when i go to turn i usually fall off anyways! so anymore i just point and shoot. Quote
SuperMex Posted March 8, 2011 Author Report Posted March 8, 2011 Offset on my stock rims was to great, I have no problems with my razors on the front. I don't ride in dirt anyways those are just to push it around. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.