bansheex666 Posted November 20, 2010 Report Share Posted November 20, 2010 Just did a top end rebuild, and when we did that we decided to do the carbs. Ling story short now it doesn't run. I cant kickstart it, so we tried pullstarting it, and it sounds like it gets a little gas, runs for a second then dies. The plugs were getting soaked in gas. It had spark, I just don't know what to look for Quote Link to comment Share on other sites More sharing options...
too_fazt Posted November 20, 2010 Report Share Posted November 20, 2010 theres a tube that runs between the two carbs...make sure its connected. Quote Link to comment Share on other sites More sharing options...
12 0 Clock P I M P Posted November 20, 2010 Report Share Posted November 20, 2010 I wish my shee had a pullstart........... MAke sure each carb went back on the right side? make sure the bowls went back on the same carbs? MAke sure about the choke tube....... let us know how u make out Quote Link to comment Share on other sites More sharing options...
bansheex666 Posted November 20, 2010 Author Report Share Posted November 20, 2010 I meant pullstarting like someone pullin me. And yes the tube is on. Today with the help or starting fluid we got it started. But the right side wasn't running and I couldn't get it to idle with out the choke out, and then after some more attempts the right side would run then Both for a second, then only the right would run, I just couldnt get it running right or stay running at all. It won't start with out the fluid, and it wont right at all. Any ideas? Quote Link to comment Share on other sites More sharing options...
bansheex666 Posted November 20, 2010 Author Report Share Posted November 20, 2010 Also replaced the plugs again today. Twice. Quote Link to comment Share on other sites More sharing options...
12 0 Clock P I M P Posted November 21, 2010 Report Share Posted November 21, 2010 make sure everything is equal and in sync Quote Link to comment Share on other sites More sharing options...
tripledsracing Posted November 21, 2010 Report Share Posted November 21, 2010 remove the tors shit 1st thing..also like was said make sure you have the correct slides in right if they are crossed it will run like u have described.. Quote Link to comment Share on other sites More sharing options...
bansheex666 Posted November 22, 2010 Author Report Share Posted November 22, 2010 Ok got everything running at 95%. It just bogs on low end. I can tune the carbs so they don't do that? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.