Having an issue

[bansheex666]

Just did a top end rebuild, and when we did that we decided to do the carbs. Ling story short now it doesn't run. I cant kickstart it, so we tried pullstarting it, and it sounds like it gets a little gas, runs for a second then dies. The plugs were getting soaked in gas. It had spark, I just don't know what to look for

[too_fazt]

theres a tube that runs between the two carbs...make sure its connected.

[12 0 Clock P I M P]

I wish my shee had a pullstart...........

 

MAke sure each carb went back on the right side? make sure the bowls went back on the same carbs?

 

MAke sure about the choke tube.......

 

 

let us know how u make out

[bansheex666]

I meant pullstarting like someone pullin me. And yes the tube is on. Today with the help or starting fluid we got it started. But the right side wasn't running and I couldn't get it to idle with out the choke out, and then after some more attempts the right side would run then Both for a second, then only the right would run, I just couldnt get it running right or stay running at all. It won't start with out the fluid, and it wont right at all. Any ideas?

[bansheex666]

Also replaced the plugs again today. Twice.

[12 0 Clock P I M P]

make sure everything is equal and in sync

[tripledsracing]

remove the tors shit 1st thing..also like was said make sure you have the correct slides in right if they are crossed it will run like u have described..

[bansheex666]

Ok got everything running at 95%. It just bogs on low end. I can tune the carbs so they don't do that?