Wayne Posted August 21, 2010 Report Share Posted August 21, 2010 can some one tell me what to do if my banshee will kick over warm but wont kick over cold and can push start cold please help out of ideas Quote Link to comment Share on other sites More sharing options...
sheeowner31 Posted August 21, 2010 Report Share Posted August 21, 2010 can some one tell me what to do if my banshee will kick over warm but wont kick over cold and can push start cold please help out of ideas check your compression Quote Link to comment Share on other sites More sharing options...
matt1 Posted August 22, 2010 Report Share Posted August 22, 2010 Whats up with the plastics? Never seen that before, are those raptor plastics. Do you run a heavy premix, I have found that even good compression motors are hard to start with a heavy premix. Quote Link to comment Share on other sites More sharing options...
#1JUANstunna Posted August 22, 2010 Report Share Posted August 22, 2010 Whats up with the plastics? Never seen that before, are those raptor plastics. Do you run a heavy premix, I have found that even good compression motors are hard to start with a heavy premix. He just told me 32:1. Quote Link to comment Share on other sites More sharing options...
#1JUANstunna Posted August 22, 2010 Report Share Posted August 22, 2010 After a few more PM's it sounds to me that yamalube @ 32:1 is a little heavy to me. Quote Link to comment Share on other sites More sharing options...
Larry's Shee Posted August 22, 2010 Report Share Posted August 22, 2010 Welcome to BHQ. By kick over I presume you mean to start/run. How does it run when you get it going? What do your plugs look like? What gap? Good spark? Fresh fuel? Does it start cold with a snort of starting fluid ?If it starts with a snort (little one !! ) then clean carbs paying special attention to choke circut. Quote Link to comment Share on other sites More sharing options...
#1JUANstunna Posted August 22, 2010 Report Share Posted August 22, 2010 Larry. From what he told me the plugs are tan and that he put in new plugs and it started and ran fine. Hopped on it the next day and it wouldn't start. He's also running yamalube @ 32:1. Quote Link to comment Share on other sites More sharing options...
ELKARACING_SHEE Posted August 22, 2010 Report Share Posted August 22, 2010 try mixing it at 40:1, i mix yamalube at 33:1, and never had a problem Quote Link to comment Share on other sites More sharing options...
Larry's Shee Posted August 22, 2010 Report Share Posted August 22, 2010 Did he wash it after the last ride? Quote Link to comment Share on other sites More sharing options...
#1JUANstunna Posted August 22, 2010 Report Share Posted August 22, 2010 I didn't ask him. I gave him a bunch of things to check when he PM'd me. Hopefully he will get back on here and check his thread. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.