Motor support for Chariot Bearing Support

[locogato11283]

Guys, here is the newly redesigned motor support used exclusively for the Chariot Performance bearing support. It will not work with any other stator covers. I redesigned the part after finding that the old design would bend the bearing support. The new support is taller so that it hits further up on the support to a stronger part of the bearing support. Posted below are 2 pictures. The first picture is the new support CNCed by JDS Customs out of billet aluminum. They turned out really nice. I have tested the hell out of the old design and they work wonders. It will keep the motor from pulling back in the frame under a hard load.

 

This is not a "fix" for Jerry's bearing support. His support works very well as designed to keep the transmission from flexing inside the cases under a load. This piece is to keep the motor itself from twisting in the frame which can cause chains to break and be thrown.

 

I have 2 of these to sell. The price is $65 shipped and it includes hardware. Bolt it on and go.

 

New Support

 

Old Support

[trademark]

so this is designed just for that design of bearing support

[locogato11283]

so this is designed just for that design of bearing support

 

yes, it will only work with the Chariot Bearing Support.

[locogato11283]

buy my stuff.

[locogato11283]

tttttttttttttttttttt