Shee not runnin right

[shakenbake1285]

My 05 shee has more air comen out of rightside exhaust than left. How can u tell if shee is ready to blow.

[VegasJeff]

most likely your carbs are out of sync. pull the air filter off and open the throttle(when it's not running) and see if they open at the exact same time.

[shakenbake1285]

How do I make them open the same time? And do I need any special tools? Thanks

[98_shee]

On stock carbs their is a site hole in the rite side and a small hole in the slide when the throttle is wide open the hole's in the slides should line up with the site holes.

[shakenbake1285]

Do I just adjust the throttle cable on top of carbs to line them up. I have the tors removed also on the carbs. And I don't need a sync tool or anything

[shakenbake1285]

My right slide (kick start side) opens slightly b4 the other side when u barely push the throttle

[Budget"shee"]

My right slide (kick start side) opens slightly b4 the other side when u barely push the throttle

Turn off your fuel remove your filter so you can see the slides. Look in the peep hole on right side of carbs open full throttle you should see a mark in the peep hole on both carbs. If not adjust the cable on top of carb untill both are visable. This will get you close.

[shakenbake1285]

I got the slides opening the same but can't see anything in the round glass piece at full throttle.

[shakenbake1285]

Thanks everyone I just got it synced. Just waitin for the rain to stop so I can try it out. How do I check to make sure the idle screws r the same? Turn them all the way in on both carbs then turn them the same amount of turns?

[Budget"shee"]

I got the slides opening the same but can't see anything in the round glass piece at full throttle.

You prob have the slides in the wrong carbs if you dont see the mark. i did this when i installed the tors removal on mine. As for the idle you can try adjusting like you said but it depends on if both carbs were modified exactly the same when adding the idle screw.

[shakenbake1285]

The slides was in backward lol. Now can't get it to idle n it has a hesitation in the bottom end.

[Budget"shee"]

The slides was in backward lol. Now can't get it to idle n it has a hesitation in the bottom end.

Well thats about as far as i got on mine and just went with a 2 to 1 set up. Im new to banshees and dont know a lot about tuning the carbs so the single worked better for me lol. Sorry i couldnt be of more help!!

Edited May 19, 2010 by Budget"shee"

[shakenbake1285]

Will idle if I choke it