jack350 Posted April 16, 2010 Report Posted April 16, 2010 ok so i think its the stator.. it had been through water without the rubber stator cover gasket.. the bike had been sitting in the garage.. now the bike under load (when in gear) does not rev but revs fine in neutrel.. the condition of the stator looks poor rusty n shit.. the flywheel is also rusty.. the bike turns on but like i mentioned it runs like shit.. need ur help need it to run by next week i have ruled out carby issue so i think its a stator issue.. what are the symptoms of a faulty stator and or CDI ?????? THANKS JACK!! Quote
2oo1banshee Posted April 16, 2010 Report Posted April 16, 2010 It could be the stator try cleaning the rust off of it with some contact cleaner and cleaning up the flywheel first before you go buy a new one. I had a similar problem with mine when I took it swimming. I cleaned it all up and it ran fine after that. Quote
AKheathen Posted April 16, 2010 Report Posted April 16, 2010 x2 on cleaning it out first thing...may need to use a toothbrush, and remove it to get it good, and make sure it gets good contact where it bolts to the plate, and only use a flywheel puller made for that flywheel Quote
jack350 Posted April 16, 2010 Author Report Posted April 16, 2010 i tryed cleanin the stator it didnt work... how would u clean the flywheel?? do i just have to make sure the 2 lugs r rust free and that the inside is clean ??? were can i get a OEM stator from too its an 02 thanks boys Quote
jack350 Posted April 18, 2010 Author Report Posted April 18, 2010 i tryed cleanin the stator it didnt work... how would u clean the flywheel?? do i just have to make sure the 2 lugs r rust free and that the inside is clean ??? were can i get a OEM stator from too its an 02 thanks boys Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.