dyna box timing

[DAN SCOTT]

Hey guys i have a 2000 shee and am running a dyna box with a nology coil and wires, just was wondering if anyone know how much curve 3 on the dyna box advances the timing? just was wondering so i know what to advance the plate too. i currantly am runnig it on +3 on curve 3 with 111 octane @ 180 psi compression on both sides. tell me what you guys think, thanks for the input

[Profilact]

i thought the point of running a dyna was to eliminate the timing plate.

[Bansh-eman]

Check the dyna site. They have a map for the curves. I think it is something like 13 degrees at it's max.

 

I ran mine at +4 and curve three when I was runing race gas on my 4mil

[J-Madd]

i thought the point of running a dyna was to eliminate the timing plate.

 

 

Yeah you can eliminate the plate if you have the cord and software to add more timing on the dyna. Any pre-programmed dyna setting could use a little timing on the plate on some motors, depending on octane of the fuel of course.

[AKheathen]

x3, there's only a few, i think like 4 max degrees over stock, but the profiles are better. it's been posted a few times in here in the past few monts, actually. another thing- it's not suggested to upgrade the coil on the dyna, since it boosts the stock ignition energy already. i don't know how many do with good results and no problems in the real world, though....

[Snopczynski]

If you set the plate at +3 and run curve 3, I believe your going to be running about 7 degrees of advance.