SD1026 Posted March 17, 2010 Report Posted March 17, 2010 bought a used round house a while ago and plan on finally putting it on. the needle berrings in it now are good but i just want to put new ones in. should i attempt this myself or bring it to a shop. i did my raptor swinger last year but i only had to put them in and it was a two hr process. Quote
SD1026 Posted March 17, 2010 Author Report Posted March 17, 2010 oh any pointers i know to put the berrings in the freezer to shrink them a lil anything else????? Quote
Bansh-eman Posted March 17, 2010 Report Posted March 17, 2010 My swingers where pretty ez to get in and out, I just had to clean the area from and dirt/sand/grease and turn it on the side and give it a tap, or grab it with my finger and pull it. Never had any that needed much wor to get out. Putting in was just as easy, added a little assembly grease, and tapped into place with a little hammer. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.