robert.b.west Posted January 31, 2010 Report Posted January 31, 2010 So I took the banshee out today and was running it around and it did not seem to want to take gas very well. It seemed like it would take it then sputter then take some more. When it was doing this if felt like it could have been running on one cylinder then two and back and forth. After taking the top end off when I got home it looks like there are vertical lines by the exhaust port. Is this a re-bore or just a hone or new rings or pistons or all of the above? Any input would be great. Quote
robert.b.west Posted January 31, 2010 Author Report Posted January 31, 2010 Here is another picture Quote
00sheerzr Posted February 1, 2010 Report Posted February 1, 2010 Here is another picture that looks like when they honed the cylinder a piece of the stone chipped off, what do the pistons look like? Quote
robert.b.west Posted February 1, 2010 Author Report Posted February 1, 2010 that looks like when they honed the cylinder a piece of the stone chipped off, what do the pistons look like? I have not looked at the pistons because I have not taken the cylinders off. It has been about 2 years since the last bore and hone and from what i remember the lines were not there. Quote
fck55mph Posted February 1, 2010 Report Posted February 1, 2010 I have not looked at the pistons because I have not taken the cylinders off. It has been about 2 years since the last bore and hone and from what i remember the lines were not there. If you dont want to take cylinders off yet, remove the pipes and use a flashlight to take a peek at the exhaust side of the pistons.. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.