joker03banshee Posted September 18, 2009 Report Posted September 18, 2009 i have a 2003 banshee with bills pipes, tors removal, and 300 mains,boysen superstock reeds,moose racing air filter. just put the carbs on i bought and is reving so high when it starts it sounds like it will blow up. i have to turn the key off within 2 ta 3 seconds of being started any ideas on wat is wrong Quote
XxMeltIcexX Posted September 18, 2009 Report Posted September 18, 2009 are the slides stuck up??? Pull off the filters or airbox whatever you have and make sure they are synced up while your at it. Quote
yamahaman244 Posted September 18, 2009 Report Posted September 18, 2009 are the slides stuck up??? Pull off the filters or airbox whatever you have and make sure they are synced up while your at it. um i had the same problem and my throttle cable was pitch and wasnt letting it come back but the throttle thumb thing would come back just not the hole cable un pitched it and it was fine just a thought Quote
joker03banshee Posted September 18, 2009 Author Report Posted September 18, 2009 are the slides stuck up??? Pull off the filters or airbox whatever you have and make sure they are synced up while your at it. no the slides are fine and are in sync Quote
joker03banshee Posted September 18, 2009 Author Report Posted September 18, 2009 um i had the same problem and my throttle cable was pitch and wasnt letting it come back but the throttle thumb thing would come back just not the hole cable un pitched it and it was fine just a thought do u meen stuck? i kno my slides ar fine n i think my cable mite b good too but ill check Quote
yamahaman244 Posted September 18, 2009 Report Posted September 18, 2009 do u meen stuck? i kno my slides ar fine n i think my cable mite b good too but ill check ya were the cable comings into the carbs mine was pitched there and was making it rev super high Quote
sleeper06 Posted September 18, 2009 Report Posted September 18, 2009 Check your intake boots for a rip,air leak.Did you just put new carbs on or clean the old ones Quote
joker03banshee Posted September 18, 2009 Author Report Posted September 18, 2009 Check your intake boots for a rip,air leak.Did you just put new carbs on or clean the old ones they where used carbs and i cleaned and put em on Quote
joker03banshee Posted September 18, 2009 Author Report Posted September 18, 2009 ya were the cable comings into the carbs mine was pitched there and was making it rev super high as far as i can tell its good Quote
2 Wild Racing Posted September 19, 2009 Report Posted September 19, 2009 turn the idle screw all the way in turn back out 5 full turns and see what happens Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.