sy1219 Posted September 14, 2009 Report Share Posted September 14, 2009 (edited) Just bought A Banshee today & I pull the clutch in & it is still engauged in gear, cable is fine, Moving on top of the case. What is the problum ??? O it has been sitting for 2.5 years. Edited September 14, 2009 by sy1219 Quote Link to comment Share on other sites More sharing options...
grizzly700 Posted September 14, 2009 Report Share Posted September 14, 2009 Just bought A Banshee today & I pull the clutch in & it is still engauged in gear, cable is fine, Moving on top of the case. What is the problum ??? O it has been sitting for 2.5 years. you gotta do three things. first use the search button. then buy a clymers. then adjust your clutch. thank you goodnight Quote Link to comment Share on other sites More sharing options...
banshee_terror_ Posted September 14, 2009 Report Share Posted September 14, 2009 (edited) push it down the rode 2 get it started then just rip it and dump the clutch threw the gears. that should help as chainging the oil that should loosin it up. it happins when they sit the plates stick Edited September 14, 2009 by banshee_terror_ Quote Link to comment Share on other sites More sharing options...
sy1219 Posted September 14, 2009 Author Report Share Posted September 14, 2009 I did go down the road with it but was just putsing. not on it at all. I was trying to get it loose. I will try it agin tonight. Will let you all know, thanks for the help. Thanks !! Quote Link to comment Share on other sites More sharing options...
Larry's Shee Posted September 14, 2009 Report Share Posted September 14, 2009 Make sure it is adjusted correctly first. Then take it out and get it up into higher gear to put a load on it,give it throttle and pull in on clutch. Do this several times. If this doesn't work pull clutch apart, steel plates are probably rusted. Quote Link to comment Share on other sites More sharing options...
sy1219 Posted September 16, 2009 Author Report Share Posted September 16, 2009 pulled the cover off tonight & the disks were rusted to the metal plates, so I took the metal plates & sand papered them, & bought A brand new Moose clutch last night so It should be ok now. ( I hope ) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.