B.Mag Posted June 18, 2009 Report Posted June 18, 2009 Ive been building a banshee from a bucket of parts so I have no idea how the clutch cable is supposed to go. Everywhere I route it doesnt seem to work out, they all look right but the cable restricts the bars from fully turning both ways. If someone could post a picture of how theirs is thatd be great. Quote
LiftdT4R Posted June 19, 2009 Report Posted June 19, 2009 Not sure if that helps, you can see the clutch cable in the pic. Basically comes from the arm, under the right side carb then up around the pipes up the stem, under the bracket at the top and into the lever. Quote
B.Mag Posted June 19, 2009 Author Report Posted June 19, 2009 Thats how I had it. I was more worried about how the cable is routed from the bars, like if its in front or behind the stem, on the left or the right and what not Quote
KaosBanshee44 Posted June 19, 2009 Report Posted June 19, 2009 Liftd has it ran right, when it comes up on the top frame support there is a little wire bracket it fits through and then run it through the front side of the bars so it lines up with your clutch assay. Quote
LiftdT4R Posted June 19, 2009 Report Posted June 19, 2009 Thats how I had it. I was more worried about how the cable is routed from the bars, like if its in front or behind the stem, on the left or the right and what not Its def in front of the stem, and then on the left in the bracket that sits there. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.