gas cap mod?

[RagunCajun]

I don't have problems. Just trying to avoid one. I haven't and dont plan to do a long pull but I want insurance.

 

So, it's drill all the way making a new hole out the inside. Thanks.

[sleeper06]

You should be fine. I've ran 188 mains on gas in the 1/4 with gas cap mod like your doing , fast billet bowls, pingle, gravity fed. You'll know if it's an issue. Usually once you get into overrev if it starts to feel like resistance it could be sucking bowls dry or lean.

[RagunCajun]

So I can put the check balls back and cover too?

[sleeper06]

Nope gutted cap

[RagunCajun]

Thanks i went ahead and did that.

 

I'm sorry for the confusion. I didnt know theres two pieces of plastic that come out in the cap. So if you drill the hole bigger, you would not run into anything. I picked up the cap and the other piece fell off.

 

I also got stopped today by the new cop living in our neighbor hood when i went test run it putt putting. Good times.

[kawa110]

Pics...

[RagunCajun]

Of?

[kawa110]

The cap.

[RagunCajun]

You really want a picture of the cap with the parts taken off of it?

[sheerider11]

Don't do it. TSS.

Can't just offer up all your knowledge.

[RagunCajun]

Don't do it. TSS.

Can't just offer up all your knowledge.

You are right.

 

In honor of control....

 

You take these off in order from right to left. Be careful because the two ball bearings will fall out.

http://i.imgur.com/akn0fBi.jpg

 

Then you end up with the cap by itself like this after:

http://i.imgur.com/xs53fEs.jpg

 

I deleted this post from last night and remade this post. I forgot a piece.