anyone running 50w trail techs thru stock switch?

[official_style]

before i take my stator out, i want to make sure this will work. i want to get my stator rewound to 200w, and run 2 trailtechs with 50w bulbs. i want them to use the stock headlight switch for power. i know i will need a different voltage regulator, but will this melt my switch and/or stock wiring? am i better off running the 35w trailtechs, until i can do the dc conversion and run leds?

[mark101180]

i did it and had no problems just tie the high and low bweam wires together so you will have light on both positions since the trail techs only have 1 beam you dont have to do that but whatever way you do it you wont burn anything up as long as it is regulated

 

[official_style]

i did it and had no problems just tie the high and low bweam wires together so you will have light on both positions since the trail techs only have 1 beam you dont have to do that but whatever way you do it you wont burn anything up as long as it is regulated

 

 

i hooked it up the way you suggested, this way if someone else drives my banshee, and clicks the lights, they wont crash, since they are on for high and low.

[Snopczynski]

before i take my stator out, i want to make sure this will work. i want to get my stator rewound to 200w, and run 2 trailtechs with 50w bulbs. i want them to use the stock headlight switch for power. i know i will need a different voltage regulator, but will this melt my switch and/or stock wiring? am i better off running the 35w trailtechs, until i can do the dc conversion and run leds?

 

The stock switch will even handle 125w of lights.

[official_style]

I have the 50w solux 4700k bulbs, I'm hoping the color is decent, I haven't tried them yet, tomorrow the stator is supposed to come in. They do look blue when there off which I don't really like.