96red Posted April 25, 2009 Report Share Posted April 25, 2009 Just looking for some ideas and help on doing the kit and getting everything set up right when i am done. Quote Link to comment Share on other sites More sharing options...
mark101180 Posted April 25, 2009 Report Share Posted April 25, 2009 if you follow the instructions that come with the kit exactly you will have no problems Quote Link to comment Share on other sites More sharing options...
Rodneya Posted April 25, 2009 Report Share Posted April 25, 2009 Use tapping oil when cutting the threads and go slow. Put something inside the carb when drilling so that you do not drill into the opposite side of the carb. Quote Link to comment Share on other sites More sharing options...
2003LimitedBanshee Posted April 25, 2009 Report Share Posted April 25, 2009 If you have access, I would recommend a drill press. When I converted mine over, I used my drill press and just set the stop; this made sure I couldn't drill through the other side if I wanted to. Good advice on the tapping oil as well. Like was mentioned, in most all cases I'm aware of, the instructions that go along with the kits are very good. As is anything when you're working on your quad, just take your time and it should come out fine! Quote Link to comment Share on other sites More sharing options...
96red Posted April 25, 2009 Author Report Share Posted April 25, 2009 thanks for the help Quote Link to comment Share on other sites More sharing options...
97stageIVBansh Posted April 25, 2009 Report Share Posted April 25, 2009 yeah man just follow teh instructions and make sure you tap those idle screw holes right, ha you only get one chance so take your time Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.