7 Mill Banshee topend

[vwpartsman]

I have a complete Banshee 7 Mill topend

 

Comes with v force 2 reeds, rubber intakes for 40MM carbs, head, domes, cylinders, pistons, and all nuts and bolts and orings for installation

 

Has had new liners put in them with 1 weekend of racing so the bore is 72MM. Ported by packard. Setup for alcohol

 

Everything is polished. Best time was 3.81

 

One piston looks like it has a minor cold sieze on the intake side of it. Was running when taken apart so you could run it like it is or replace the one piston.

 

$850 shipped

 

[vwpartsman]

up

[jaydun323]

7mm bore or stroke? TREX has alot of different options.

 

[krazy_sw]

Ill give you 500 shipped for it

[1996dragshee]

Ill give you 500 shipped for it

 

 

Dude that's just an insult of an offer IMO.

[vwpartsman]

Topend is for a 7 mill stroke and its at 72MM bore which is the bore when you get them. lots of life left in the liners.

 

I'll pass on the $500 offer

[krazy_sw]

what about 650 shipped

[vwpartsman]

$750 and you have a deal

[Darthwall]

$750 and you have a deal

 

give this guy a fair price I know 7mm stuff is hard to get rid of but a 3.81 is damn good packard is no cheap company to go through

[1996dragshee]

$750 and you have a deal

 

These cylinders cost a pretty penny brand new out of the box no porting... $1800 +. So 750 already ported with v force reeds and new sleeves,this is a damn good deal as it sits. Just the cost of re-sleeving and port matching ranges 4-500.

 

Bump for ya bro!

 

 

[krazy_sw]

will it work with a 4 mil crank

[vwpartsman]

will it work with a 4 mil crank

 

You would have to have the cylinder milled down to fit the 4 mill crank to make your port timings come out right. So yes it could but not like it is right now

[vwpartsman]

SOLD!!!!