jimbob Posted January 3, 2009 Report Posted January 3, 2009 ok guys got my barrels back today after a fresh rebore and hone, gonna put it together soon, any words of advise from the wise sages about procedure? Quote
1996dragshee Posted January 4, 2009 Report Posted January 4, 2009 Top end is simple.Just make sure you put the pistons in facing the right way and should be good to go as long as everyhing is tightened down.good luck Quote
98_shee Posted January 4, 2009 Report Posted January 4, 2009 I alway Clean the cylinders to make sure thier isnt anything left from the bore and hone, then coat cylinders, pistons/pins/bearings, and crank bearings with whatever 2 stroke oil you run. Then start putting it together. Be sure the rings are in the pins that are in the pistons. Quote
jimbob Posted January 4, 2009 Author Report Posted January 4, 2009 ok thanks. any advice on breaking it in? go easy for 1 tank? plenty of oil? Quote
Wildcardracing Posted January 4, 2009 Report Posted January 4, 2009 Do 4 heat cycles, then retorque the head and cylinders. Do a plug chop to verify jetting Quote
BumpaD_Z28 Posted January 5, 2009 Report Posted January 5, 2009 (edited) Top end is simple.Just make sure you put the pistons in facing the right way and should be good to go as long as everyhing is tightened down.good luck Sorry for the hi-jack, BUT is there a Way to tell which way the pistons go ? I'm ASSumng there is a "front" but haven't ordered my replacement WISECO's yet ... ~DaVe Edited January 5, 2009 by BumpaD_Z28 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.