Jump to content

Recommended Posts

Posted

OK so I picked up my first shee today it has a problem I can not figure out it will idle for about 3 sec than die or you can give it just a little gas bring the rpms up a little and it will cut out like some one is turning the key off than back on real fast but when you wind it up just a little about mid range its fine just down low its stock just has fmf pipes any one had this problem thanks

Posted (edited)

what year is the bike?I say you pull the airfilter and give it a good cleaning.Pull the carbs and do the same thing.Go ahead and replace the plugs.Put in some new gas and don't forget the oil.Try those things and check back. Probably want to check the compression also.

Edited by shee4speed
Posted
OK so I picked up my first shee today it has a problem I can not figure out it will idle for about 3 sec than die or you can give it just a little gas bring the rpms up a little and it will cut out like some one is turning the key off than back on real fast but when you wind it up just a little about mid range its fine just down low its stock just has fmf pipes any one had this problem thanks

air screw too lean or chek for air leaks between the carbs and juggs by spraying starting fluid there while it idles. i wouldn't suggest tearing into the electronics without testing the spark and adustments first.

Posted (edited)
air screw too lean or chek for air leaks between the carbs and juggs by spraying starting fluid there while it idles. i wouldn't suggest tearing into the electronics without testing the spark and adustments first.

 

air leak usually will cause the engine to rev higher not cut out. Just clean the carbs out good and go from there. More than likely just your pilot circuit...(pilot jets)

Edited by bansheejoel

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...