bansheeboy01

on pump gas

what size stroker crank can I run with stock cylinders and with what size coolhead domes?

yes but I did 2 turns out not 1.5 but they are both the same

I just took the carb off and blew all the jets out with carb clean and non of them seamed to have dirt in them and if there was there isn't now and still having same problem

I just took the carbs out inspected and cleaned.. they seem fine...Now!.. when I put it back together I noticed that the cylinder that has been giving me trouble runs perfect at half choke when I take the choke off completely it gets weeker and back fires a tiny bit anyone have suggestions I just rebuilt the bottom end and topend so I no its not the rings

iam thinking its ritch because I drove it out of the woods on one cylinder.. the cylinder that wasn't firing is now slinging oil all over the spark plug

my banshee runs good but plug keeps fouling on one side I had to drive out of the woods on only one cylinder so I am thinking the side that is fouling is fluded what do you guys suggest I do ? it runs good when I put a new plug in it but fouls after a cupple seconds after start up.

banshee ran fine .. did a rebuild and now has no spark ?

Doing a bottom end rebuild , thinking about buying a hotrod crankshaft what other little things can I do?

do you still have the elka shock?

who has a chool head with gas domes?

what is the highest amount of compression you can get and still use pump gas ?

use a ball peen hammer and a chizzle when needed

I want the coolhead can u send some pictures?

will u sell the coolhead for 90bucks ? I will buy it