Juss11

You didn't get the float bowls switched when you had the carbs off?

God?

lol

Thanks guys, think I may grab a set

I see a guy has a bunch of 30mm OKO, for like $150 a set shipped, in the 4-sale section. I was going to either get some PWK 28,33,34 mm etc for my 4mil dune port. Are these worth even messing with? I hear people say they run out of fuel on WOT but im sure that's just a float adjustment.

I think I would have more fun on my RMZ450, than my banshee, playing on those trails!

Does this bike still have the Tors on top of the Carbs? If so unplug all that shit and see if it will run. I had the same problem.

I buy the walmart brand type F, for like $2 A qt.

So just wondering what carb set up should I use? I sent my cylinders to herrugs racing , got the 4mm dune port with custom cut domes for pump fuel.. He bored them to 65.5.I got a hotrods 4mm long rod crank. Going to run v-force 4s with pods. So now that leaves me to what carbs to run? I hear 34MM PJs or 28MM pwks etc? Or should I just run my stock carbs? Will I see a big difference over stock carbs with my set up? Also I have a adjustable timing plate and T5s for my exhaust. Thanks for any advice given.

Thanks guys for the info. I ordered one from the dealer but will see if the side cover dowl is the same for now. Thanks

So I split the cases on my dads banshee to change crank and notice no front dowl pen. Where can I get one? Can I get away without it?

Im looking for a swingarm chain guide. I see TM Desighn and Modquad. Whats the best out of those two?

Thanks for the greeat info. I looked into the Mull one and they are on back order, so I got a pro desighn. Funny they had it listed for $58 for the RZ350, and same seller had it listed for $70 for Banshee.

Let me know what you have, new ones are going for around $60

I see on ebay they are going for $70 for the pro desighn one & $50 for the Modquad and Boss ones. Any difference?

Ya I put a max load On my coutershaft

I thought they were the same? Sproket side bearing & Rt side crank bearing the same?

The case are bolted together then the bearing holes are bored as a matching set. If you dont have mathcing set you will have problemes.

Did u set the gap on the pick up coil?

oic

That's true, but strait water will cause rust etc. Guess if you flush it out more often be ok

. I don't see where he said anything bad about you. You forget to take your meds today? lol

Thanks

btw did not find any leaks with windex

I just got my Banshee engine built , ran a pressure test. After about 6 minutes, it barley dropped of 6psi. I left it on for 15 minutes & it droped between 6psi & 5 1/2 psi. Think thats ok?