Zillaguy
-
Posts
744 -
Joined
-
Last visited
-
Days Won
2
Content Type
Profiles
Forums
Events
Gallery
Store
Posts posted by Zillaguy
-
-
NO way it went 112mph! Not possible mechanically... My LT500R (Quadzilla) that is a 650cc DR.Q "Roidzilla" motor, with a DR.Q pipe will go 112 but not a mildly built at best Banshee... My new project, 94 Banshee with an 84 Yamaha RD500 V-4 (4cyl 2 stroke) motor will rip about 150 in a straight line with the right tuning... Got the idea from Robert (DR.Q) he built a Zilla with a Suzuki Gamma 500 4cyl 2-stroke motor... Go to youtube and listen to that bike!
-
1) What type of aftermarket exhaust do you have? FMF Gold's W/Power Core II's
2) What type of airfilter do you have? K&N Filter PODs w/Outerwears
3) Are you a)running a stock airbox with lid stock airbox with NO lid c) Stock airbox with vents d) no airbox at all? NO AIRBOX
4) What is your elevation? 600 - 900 ft
5) What size pilot jets are you using? 27.5
6) What size main jets are you using? 290
7) What temperature is your Banshee jetted for? 65 - 100
8) Do you have a port job? casting clean up, polished exhaust ports, no port mods
9) What kind of carbs? Stock Mikuni w/TORS Elim.
10) What size carbs? Stock
12) Do you have a coolhead? yes
13) What brand is your coolhead? PRO DESIGN
14) What size domes are you using? 20cc
15) What type of fuel are you using) 93 pump gas
16) What gas/oil ratio you use? 32:1
17) What type of premix you use? KLOTZ R-50
I also have Pro-design billet intakes w/NO crossover or boost bottle, and V-Force III's, the engine is also .050 over with Wiseco pro-lites
392cc Athena kit.
in Banshee Repairs and Mods
Posted
It will be bitchin!! The rd500 motor i'm using is .050 over race ported and polished, has had the power valves massaged, and has a set of hand coned pipes custom made by Eric Cook from PFR racing. The motor dynoed 130hp @ 11,600 RPM and 83lb/ft of torque@ 9300rpm.. I had to take my Banshee chassis jig it up, cut it to pieces and make new front down tubes and make the entire engine cradle from scratch... The lower frame rails are now 2.5 inches lower than a stock Banshee chassis to make room for the height of the rd 4cyl... I'm running a +6 swinger w/ a wheelie bar, single a-arm conversion... This is going to be a badass drag bike when done.. I'm setting it up for ashphalt, to run 1/4mile at Milan dragway in Milan,Mi. this summer. Hoping the bike runs low 9's.