Banshee Price910

Got it solve it was the pick up gap. She screams and pulls hard again thanks for the help

It has spark and is getting gas but its like the cylinder is completely dead at all rpm's. You can hear that is not working properly as soon as you start it up. Compression is 115 on both cylinders.

New plugs, switched the plug wires and cylinder is still not hitting. I havent had a chance to check the compression. I just changed stator plates due to the fact the old one cracked. Could that be my problem? Carbs are in correct. Reeds check out fine too.

Okay here's my problem, my left cylinder has spark but its like its not hitting. Right cylinder is fine. My mods are just full fmf pipes, open airbox with k&n air filter. Plus 4 timing. Im at 300 ft above sea level carbs been cleaned and are in sync, carb tube in place. Please help

I need stock cylinders with bore no more than 65

Do you still have those nerfs

Do you still have the nerf bars

What's the bore size

Pm sent

Im trying to buy a set of stockers. Would like them to be ported but if not stock is cool to. Mine are done and im not trying to do a big bore build

Anyone have a nice set or stock cylinders for sale. I would like for them to be ported but if not that's ok to. Mine are done.

I think I do have a air leak cause I tried the 320 today and the plugs are still coming out white. Is there any where I can get the tool to do a leak down test

Plugs are white, but no popping or losing power. 320 rounds too rich to anyone I ask.

Im new to this site and I know its forums about jetting but here's my problem I have a 2002 banshee everything stock except I have full fmf fatties with K&N air filter with no lid. Im at appox. 400 to 500 above sea level. 27.5 on the pilot, clip in the middle, 300 on the main and its still lean on both cylinders. Brand new top end, im not trying to melt it down so can anyone please help? Thanks