3Yamaha5Banshee0

and another problem i have been having with my Pod Filters is that at a idle you give it gass and it will rev up then back down and then slowly rev back up when your thumb is off the throtle, any ways to fix that?

every banshee i have heard with pipes (dont madder the kind) are always wayyyyy toooo lound and i hate it

How did you do the compression check? I always take a plug out put the threded thingy in were the plug was at and with the Key OFF kick it 3 times

thats funny because i was JUST looking at them tires on the internet lol, sound like a good deal too

Holeshot is a pretty popular tire, i have heard nothing but good things about them. i think i might go with them my next pay check lol

trails, grass, dirt road kinda an all arround tire

I still have the stock Dunlop tires on my 2000 banshee they are getting really worn down, i was wondering what is the BEST tire for the rear. Im looking for something with a low profile tire that site level on the ground and not like a balloon Thanks, Dustin

yeah most water my bike sees is from wet grass, and if im thinking correctly i think i have to have a jet of 280 is that correct?

I just bought some K&N air filters i put them on a rejetted my carbs and i started it up... every times i give it gass you can ear the carbs sucking air, it dont sound verry "cool" its actualy pretty loud is there any way to stop this from happening? AND is it even a good mod to use? or should i go back to the huge and hard to install air box?

i think a stock banshee off the show room floor has 125-135 compression, my 2000 all stock is running about 100-105. guy in my local ATV repair shop said that a bike anywere under 50psi will not run thats the limit

i did some investigating and when you first start it up (cold) it back fires every 3-4 seconts untill its warmed up. and only on the right cylinder. i cleaned carbs again and hooked that choke tube back up on the correct nipple and it still does it

dude the oil in your gass is what lubes your piston rod bearings, with absoutly no oil its going to seize up big as shit. no oild your running ti way to lean and hot, my burn a hole right in the top of the piston.... and yeah sounds like im a noob...

Klotz smells so bad lol, and you dont run any oil? i will see you in the next "BANSHEE ENGINE REBUILD" in the Images fourms

What oil should i run in my banshee and what mixture, im running AMS oil domonator in it right now at 50:1

i have done all of that pleanty of times, i still dont understand