Mike27

any interest in trading for a set of drag arms....with one trip

really wanting a price check on my shee to figure out if im going to sale it or part it out. not sure which I want to do yet. Motor is pretty much stock with a newer topend. has new arms, new swinger, tors removed, full boar plastics, lazer lights, just PC'd with no rides. new chain and sprockets.t5's, k&n filter pods. I also have a new seat cover coming and has new grips on it. bike also starts first kick almost everytime. i will make a video of it running tomarrow. any other questions let me know 2,500 and open to all offers. pm me or easier just to call or text me 805-540-8833

no i havnt checked compression yet. may do that tomarrow.

i have a 2004 banshee with t6, foam filter, no air box lid. stock porting. has stock pilot and 270 main. i know the main needs to go up bout 1000 elevation....70's outside. my buddies bike will not start cold. I can pull start it then once its warmed up it will kick over for me. but once it sits for a half hour i have to pull start it again.. thanks for any help mike

im looking to trade my drag arms for some extended mx arms. must be in like condition. dont want beat up junk. mine are PC'd Black and new tie rods, new tie rod ends, and new Arm hiem joints. they are stand length. thanks mike I will get some closer pics later. but this is what i have for now.

so back end off the ground with the banshee running in N.... and what about the clutch arm marks...r they supposed to line up with the clutch pull in....cause if not it looks like mine is pretty far off.. mike

alright I just put my banshee all back together after getting everything PC'd. So the motor had been sitting for about 5 months. finally got everything together and everytime I go from N to 1st it lunges and dies.....It didnt do this before so i want to find were these adjustment marks are before I tear into the clutch... heres some pics of my setup....let me know if it looks right.. thanks mike

alright im looking for a few things....used is fine but good condition. look for swing arm bolt swing are bolt carrier brake hub and sprocket hub front tires. also need to replace the following if you happen to have them...prefer new or almost new front and rear spockets....close to stock is fine chain for +6 4 carrier bearings for stock size axle hand grips 3/8 hiem joints for drag arms. let me know thanks mike

alright i will check it out right now.. mike

Hey guys im looking to get some bearing kits for my 97 banshee.....im looking for upper and lower a arms, swing arm bearings plus swing arm bolt, i checked out ebay but 160 seamed exspensive for a arm kits. were are you guys getting yours and what should i expect to pay for both kits. thanks mike

im looking to either trade these or sell them. they are going out to get pc'd in 2 weeks so they will have fresh powder and new ends. any more questions let me know thanks mike follow link http://bansheehq.com/forums/index.php?showtopic=124296

hey guys bought a banshee that had some drag arms on it. Im trying to trade them for some extended a arms. I also have some billet tie rods that go with them but didnt want to dig them out. I will be sending everything out to powdercoating in 2 weeks. so they will be fresh and will also have new ball joints. not a 100% sure on the brand but they do look identical to my RIS arms for my 450R. I know the tie rods are for sure from RIS though. let meknow if you have any questions. mike arms only 4 3/4 pounds arms and stock spindles(I think they are stock) 9 3/4 pounds