byrdmanracing

some one got to have stock or aftermarket stem or carrier bump

its all stock parts off a 04 shee. its everything but the top end

what parts r u looking for and ill take pics and post it if i have it. i will take pics of what i have know, and post it

need steering stem and axle carrier. post pics and price shipped to zip 40065 thx

if any one got a carrier and stem laying around in good shape, and want to trade for some engine parts? hit me up

i would check the head and the reeds. the comp should be no lower then 85. for a fresh eng. u need around 100 at least

ya that mec. candy red will look good

bump>>>>>>>>><<<<<<<<<

80 over bored wiseco pistons new stock crank 330 main jets shaved heads toomey t5 pipes k&n filters bullet alum. parts ac nerfs blingstar front bumper renthal bars and inch risers has about 15 hours on it and the rear hole shots the same. i built it in april. and i run 38:1

ill try dropping the needle it should be on the 2nd clip. im running 330 on the 2nd clip and 50:1 mix. im 60mm over on the pistons. so drop the needle and see if that helps. o ya how many turns is u fuel srew?

ur running rich. where r u from?

what is ur fuel mix

trader!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! just playing. u got to do what u got to do man

o ya and welcome to the bhq.

when i break my shee in i run 28:1 and do three heat cycles. drain the tank clean the carbs. then run 50:1 and balls to the wall. if its going to break then its going to break. i race and i always rebuild once a year to freshin up the motor. never had a problem yet.