Banshee Boy69

ok thanks man, i'll see what happens tomorrow. If it wasn't for this forum i'd be riding a sick Banshee. good ta know there are some guys out there that love their Shees enough to go through hell and back to keep em going, like me.

thanks for the help man i'll do that. what do i listen for to tell when it's right, how will i know?

hey guys how do you adjust the idle screws on the tors boxes? how do i know when they're right?

hey guys how do you adjust the idle screws on the tors boxes? how do i know when they're right?

well the bike was running great before, It was built when i got it,(lots of aftermarket parts) I took the motor off then put it back on and now i'm having problems. i now have slack at the throttle but can you give me more info on how to adjust the idle screws?

it don't seem like the idle screws are workin right but I think i have a throttle cable problem too, when I turn the idle down too low the TORS will shut the motor off

ok i'll try that and see if it works, i don't really have any slack at the throttle lever or on the TORS caps. when i tightened it up before it would rev high

i know it's my idle but how do i get them both perfectly even? i don't think the fuel/air screws are the problem cuz it was running fine before.

it's not my jetting cuz it was runnin perfect before and i have a white bros boost bottle. if i turn the choke halfway on it will rev up better and idle higher

Hey guys, me again, well i fixed the problem before when it wouldn.t rev but now i have another problem. my banshee will idle ok but when i go to goose it, it won't take it but if i slowly rev it it is fine and if i rev it up a little when i goose it it does just fine. and how do i adjust the idle screws on top the TORS boxes? I don't think their right

there is a mark on the slides, you look through the sight window on the right and adjust the left till they both line up in their window, they say not to adjust the right side

I fixed it thanks to you guys. i switched my caps around and DING DING it revs great, the only problem i have is that it seemes like the throttle is sticking but i think i can figure that one out once again, THANKS to everyone. i'll try to help with some problems you guys have. I appreciate everything from everybody I hope this forum helps someone else in a sticky situation like i was you guys are GREAT THANKS A LOT

thats some funny shit, i've never needed help gettin it in before. lol but that isn't the problem, i guided the needle in to the hole and it still won't slide down but maybe 1/8 of an inch.

the slide being backwards is my problem but when i go to turn them around they won't go in all the way what is wrong?. thanks guys a lot i really appreciate everything

that's what i thought and i didn't figure it would hurt n e thing. I unhooked my tors box just to be sure and it didn't help. it just acts like it's runnin too rich, kinda like a 2 stroke acts when it's cold it won't open up. but my motor is built a little and it has been tuned by a pro at Bubs Cycle so i kow the jets aren't the problem.