Boominrick

Hey man that looks awsome! I'm doing the rz motor right now also. Not as bad ass as yours tho. I just got my stock powervalve stuff in yesterday. All I need is a cdi.

do you have the cdi? i need one

i need a rz cdi if anyone has one.

how much is there cdi? I was looking at a dealer in the us and they sold the cdi and PV controller for $700. That's a bit to much for me. Do you know how much just the cdi is? I don't need it to work will the banshee stuff just the rz stator and rz PV controller. I still have to wait for the stuff to come in anyway. Then build a wiring harness so I have a little time to try to find one.

that will be sweet if you have a extra. the parts that i have (well that are coming from ebay) are. the stator, powervalve pully thing with cables.powervalve servo/motor powervalve controller, and the eletrical regulator. and these are off of a 85 bike. i read that i can use my banshee flywheel, so i did not buy the flywheel. i also did not buy the harness. i figure i prety good with wiring so i give it a shot.

anyone?

bump

i got all my electronics for the RZ350 swap except the cdi. (guy sold it right away) the only one on ebay right now is buy it now for over $200. i allready dropped $370 for these electronics and i dont want to spend anymore! i've been searching for 2 days now, im not going to go with zeeltronics, i got all the rz stuff. does anyone know if a cdi from another bike will work? thanks in advance people rick

ok, i got all that stuff on ebay. i just need the cdi, and the pulley cable thing that attaches to the powervalve! come on ppl

here are my $10 wal-mart specials

i have the rz350 jugs n my shee and i want to make them work. i need everything but the jugs. thanks rick

they do look the same. hmmm well here is the most recent pic of my baby before i took her apart today

here are the pics this doesnt look good! detonation? other side looks ok tho i pretty sure the carb is a DG keihin pwk

The intake setup on the bike is Vforce reeds, 2-1 manny and a pkw? Carb. I think that rings a bell. Not sure if the bike was overheated or froze. Any way to tell?

The power valve is not hooked up. I do not have the eletronics for it but I'm looking for the stuff on eBay. I bought the bike with this stuff already done. Maybe I will have to repair it. Also if anyone has information on where I can find the power valve stuff that would be awsome