sir_247

well after i put the motor back into my shee i turned it on and i had put the needles wrong and was at full blast after that i put the needles in the proper position and my shee ended up with gunked up carb so i pulled them and got the jets and the main mixed up my question is are they the same or is on bigger or smaller thanks for the help

i pulled the motor from my banshee and im going to put it back now but can seem to find where this hose went

yea i did and they do feel fine but 5 and 6th dont go in??

well after talking to the guy who rode my bike he ******* said that he "might" have slamed a gear down at high revs! idk if this helps???

what do you mean indexing wrong what way should it rotate?

well i got it to run in 2nd and in 4th idk????

well i adjusted it and still no go it turns on and when i let the clutch go it doesnt go anywhere buy it doesnt shut off any more you put it in gear and when you let the clutch out it revs but doesnt go anywhere i got the shift shaft thing and adjusted it

well i installed the new clutch kit and pancake and no go it still does the same thing i need help guys dont know why this is happening i didnt adjust the shift shaft, can that be causing this problem?

i get it a little but its not clear, what do i bend and what am i looking for is it the space with that star and the little lever? thanks for the help everyone i ordered my cluth basket inner plate and clutch with the pancake

do you guys know what the size of the clutch boss nut is?

does the pancake replace this?

so basically all i need is a clutch basket and clutch and springs and a pancake do i need a new gasket?

the shift shaft is all the way in where does the pancake go?

ok so i got it in neutral and what is the shift shaft???? is this it? other

i noticed that the clutch basket has like groves going towards inside as if they were slanted is that wear? so the bike should kick in to neutral?