bad boyz cycles

Im heading out there with some of my customers to run the bikes they were going to bring some of there freinds along so it sounds good bring some bikes out this weekend.

WHAT SIZE AREE THOSE SPACERS?

Thanks for the info. I heard that a a lot of guys are going ot go to holy land this weekend to race. Has any one heard any thing?

I rather get a few tickets then get arrested. so the heat has gown down in kendall? have you seen alot of guys down there i havent been ridding in a while and customers are saying that every where they go its a heat up.

ANY ONE KNOW WHERE EVERY ONE IS RACING NOW IN MIAMI IVE HEARD OF SOME GUYS UP IN HOLY LAND BUT JUST WANT TO MAKE SURE THEY ARE RACING UP THERE SO THAT I WONT MAKE THAT DRIVE FOR NO REASON!

I would like a set of cylinders that are no good and need to be resleeved or that have no hope that some one is going ot throw out. an help would be appreciated.

Looking for a set of american racer tires 20-10-10 sd23 swing arm at least 6 over or more a decent set of cylinders with stock port perfered. also a set of carbs pwk. Thanks [email protected]

Looking for a set of cylinders for a good price. let me know [email protected] Thanks

i got it working now it was my seat i replaced the seat and the floats with another set of carbs that i had laying around and it stoped over flowing and i cranked right up. thanks for the advice

I cleaned out both carbs after putting in the pingle valve and flushed the tank cean of all trash one side runs great the other side turns one if i put my hand over the intake of the carbs. if i unbuild the carb and ake off the pilot jet and put ti back to gether it runs like a champ for about 30 sec thens one side turns off and does nothing till i put my hand over the carb. andd that side keeps leaking gas out of the bowl. i have unbilt the seat and built back and it stops for a bit then starts doing it again. help me out i want to go ride this saturday. thanks

how much will a set up like that run me? also will this act up when im riding trails

im looking into getting my cylinders resleeved to a big bore and was wondering if it was worth it. Has anyone done it?

what is the bore and how are they ported call me if i dont reply by tommorow night i might beworking on the bike and not get a chance 305-970-2353 Irving

please give me a call 305-970-2353 Irving

are the cylinders still avaliable

any one selling some stock cylinders email me