jay shafer

Matt Willis just ran a 5.29 at 123 this past weekend

You can but this is quicker and easier for me...its already mixed and just pour in and its 94 octane also . Some people cant get 93 octane in certain areas.

I Run Vp M1 Methanol and I purge with the vp 50:1 already mixed fuel that you can get from any hardware store, home depot, lowes or any small engine shop. Its already mixed and its high octane. Pour it in start it up run until it barely can run. Purge complete.... http://www.homedepot.com/p/Unbranded-VP-Small-Engine-Fuel-50-1-Pre-Mixed-94-Octane-Ethanol-Free-Single-6235/203526823

Sent from my SGH-M919N using Tapatalk

Sent from my SGH-M919N using Tapatalk

10mm 75.5 bore....i see the adaptor plate u talking about but i looked at the intakes in my cub motor and its not even close to being the same....the bolts on the cub/rdz motor is closer together than what is on this twister motor

4 bolt Sent from my SGH-M919N using Tapatalk

Well I'm looking at them and they are not the same as my cub cylinders at all... Sent from my SGH-M919N using Tapatalk

Ban565 where can this adapter plate be found Sent from my SGH-M919N using Tapatalk

I'll look at my other cylinders and see if they are the same and hoping they are but if not I will call those two thanks j-madd and others for the replies Sent from my SGH-M919N using Tapatalk

Does anybody have any intakes a mini twister for a set of 44 lectrons Sent from my SGH-M919N using Tapatalk

And his bullshit continues....only ones doing business with him are right there in his own area but he has passed off a few of them also

lol not with me

I dont know if he is a site sponsor or not

ok these are 7mm rdz eliminator cylinders that i paid well over a 150 for a porting and upwards of a 1000 for this. I have played with this motor for too long for it not perform better than some stock cylinders that i had before. I have seen this mans work on some cylinders before i got these and it dont look anything like this. His actual words were "this is the BEST he could do"....go figure....