98 shee devil Posted August 19, 2008 Report Posted August 19, 2008 just got the motor back from fast racing all put together i just had a few questions before it goes back in the frame... how mauch oil does it take again i forgot and theres a hole on the top of my block it looks like it goes inside of the actully case(where the oils is) ..is this normal i mean the whole motor was rebuilt by a professional, i doubt he over looked this but could be possible...heres a picture. and if anyone has some more tips for me to make the motor install easyer.... let em rip because i want it to go as smoth as possible..thanks and peace..the hole is in the bottom left hand corner..and on the motor, if you were looking down on it as if you were sitting on the seat its on the left side right behind the cylinder. Quote
Wildcardracing Posted August 19, 2008 Report Posted August 19, 2008 No problems there, that hole is just a drain hole so the gas/oil and water don't pool on top of your case. I think it's 1500cc of oil off the top of my head, about a quart and a half. Make sure to do some plug chops to get your jetting dialed in before you take it out on a good ride. Quote
KaosBanshee44 Posted August 19, 2008 Report Posted August 19, 2008 I put just under 2 quarts in mine and that hole on top of your cases is a drain hole for water that gets on top of the cases. It's perfectly normal Quote
98 shee devil Posted August 19, 2008 Author Report Posted August 19, 2008 (edited) thanks for the fast reply guys.. so the hole is fine if its left open? or does some sorta rubber gromet/stoper go in there? ohh and im running a trinity 2 into 1 carb anyone got some jetting specs for me in at sea level, summer time bout 70 to 80 degrees... Edited August 19, 2008 by 98 shee devil Quote
Wildcardracing Posted August 19, 2008 Report Posted August 19, 2008 No, just leave the hole open. As far as the jetting, post a list of all of your mods as well as port type. Someone will have some input for you. I won't be able to help ya much on the 2into1...don't deal with those. Quote
98 shee devil Posted August 19, 2008 Author Report Posted August 19, 2008 my parts are all listed in my banner or whatever its called under what im writing now. no port job...next time. thansk fo rthe help. im reading the jetting post but not to many are about 2 into 1's Quote
Wildcardracing Posted August 19, 2008 Report Posted August 19, 2008 my parts are all listed in my banner or whatever its called under what im writing now. no port job...next time. thansk fo rthe help. im reading the jetting post but not to many are about 2 into 1's PM Snopcynski (SP), he knows the 2into1's bout as good as anyone on here. Sorry, guess I assumed you had jeff port it too. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.