Kill Switch

[PROXT]

I have just brought a brand new kill switch. There is no instructions to it. It has 2 wires. Where do i hook it up to. Any help much appreciated.

[rubberneck]

I have just brought a brand new kill switch. There is no instructions to it. It has 2 wires. Where do i hook it up to. Any help much appreciated.

 

Ok, I am going to assume it is a tether kill switch that you are adding in addition to the factory one right?? One wire from your new kill switch goes to ground. Doesn't matter which one. The other wire needs to go to the kill wire for the CDI. There is a black wire with a white stripe on it that goes up to your factory handlebar mounted switch assembly. You want to tap into that wire.

[PROXT]

Do you go into the run switch or the key switch.

[rubberneck]

Do you go into the run switch or the key switch.

 

 

The run switch, or you can go into the harness down by the tank.

[sa3ood_banshee]

if its a tether kill switch check this out :thumbsup:

 

 

 

sa3ood

[rubberneck]

if its a tether kill switch check this out :thumbsup:

 

 

 

sa3ood

 

 

Do not do it that way. That method will in fact work to kill the bike, but according to info on this site, that method of grounding the coil is hard on CDI's Do it the proper way and tie in to the black white kill wire designed to shut the bike off.

[sa3ood_banshee]

Do not do it that way. That method will in fact work to kill the bike, but according to info on this site, that method of grounding the coil is hard on CDI's Do it the proper way and tie in to the black white kill wire designed to shut the bike off.

aha,thnx for advice bro

 

sa3ood