pkw 35 mm single

[gmctruck1976]

Ok guys i just got done reading a bunch of these post and im completely lost.

Im building, 4 mill with 110 rods, 21cc domes with the 2mill milled for crank, trinity single carb 35m

v force 3 reads and fmf fatty. stock port. ill be running 93 oct @32 to 1 mix synthetic elevation aprox. 200ft ave. Humidity runs on ave around 60 to 70 %

where do i start, who sell a good jet kit with at least a few different set ups to use. IM not sure what all cam with the new carb. so i cant give info on that right now just looking for a starting point for my build.

I do rebuild alright but when it comes to carb set ups im completely lost any help wiould be gratefull

[Snopczynski]

Ok guys i just got done reading a bunch of these post and im completely lost.

Im building, 4 mill with 110 rods, 21cc domes with the 2mill milled for crank, trinity single carb 35m

v force 3 reads and fmf fatty. stock port. ill be running 93 oct @32 to 1 mix synthetic elevation aprox. 200ft ave. Humidity runs on ave around 60 to 70 %

where do i start, who sell a good jet kit with at least a few different set ups to use. IM not sure what all cam with the new carb. so i cant give info on that right now just looking for a starting point for my build.

I do rebuild alright but when it comes to carb set ups im completely lost any help wiould be gratefull

 

PWK 35mm= 200 main, eej needle, clip 2nd notch down from the top, 45 pilot jet, air screw 1.5 turns out from all the way in. Hopefully your running a pod filter?