Need help with my jetting

[quikshee]

OK i just bought some uni pod's, FMF gold series fatty's and toomey silencers, the rest of the bike is bone stock. I'm at about 650 ft above sea level and its between 70-95 degrees where i'm at,I'm running stock carbs with 200 mains and 25 pilots. Anyone have suggestions on where i should have them jetted at??

 

thanks

[1996dragshee]

OK i just bought some uni pod's, FMF gold series fatty's and toomey silencers, the rest of the bike is bone stock. I'm at about 650 ft above sea level and its between 70-95 degrees where i'm at,I'm running stock carbs with 200 mains and 25 pilots. Anyone have suggestions on where i should have them jetted at??

 

thanks

 

 

270-280 mains 27.5 pilot.middle clip on the needle.better to start rich and lean it out. .25-.5 turn out on the air screw.should be pretty close.good luck :thumbsup:

[quikshee]

alright i'll give it a try, thanks :biggrin:

[ASRBanshee]

I would try 310 mains and 27.5 pilots. 270-280 seems a little lean for pods.

[mopar1rules]

i would start out at stock needle w/clip in middle pos, 27.5 pilots, 2 turns on air screws and 310 mains. could possibly go back to stock pilots. you might need to go to 320 mains, but i doubt it.

Edited June 26, 2008 by mopar1rules

[quikshee]

Alright guys, all your help has been great but the DOUCHEBAG whom i bought the pipes and silencers from, sold the entire quad on me and a few others who had bought from him. So nix the pipes and silencers for now, until i happen upon another $130 set of pipes/silencers :biggrin: