wood Posted October 25, 2007 Report Share Posted October 25, 2007 i thought the slides could only go in one way. Quote Link to comment Share on other sites More sharing options...
Snopczynski Posted October 25, 2007 Report Share Posted October 25, 2007 left to right and vice versa. You probably should make sure the choke balance tube is on while your at it. Quote Link to comment Share on other sites More sharing options...
jaredvh Posted October 26, 2007 Author Report Share Posted October 26, 2007 Well..when my banshee was warming up today I decided to try something. I covered the left exhaust tip and there was pressure there but nowhere near as much as it should be because it stayed running. When I went to caver the right tip the banshee just about stalled out but I uncovered it before it stalled. I'm kind of worried now because I dont assume that it's a good thing Quote Link to comment Share on other sites More sharing options...
Snopczynski Posted October 26, 2007 Report Share Posted October 26, 2007 do a compression check. Quote Link to comment Share on other sites More sharing options...
The Rebel Posted October 27, 2007 Report Share Posted October 27, 2007 switch reeds and see what happens. it could be bad pedals. Could be bad "pedals", I had to replace the pedals on my baby's tricycle once because one side pulled harder than the other causing a terrible drift when under power. Quote Link to comment Share on other sites More sharing options...
The Rebel Posted October 27, 2007 Report Share Posted October 27, 2007 i thought the slides could only go in one way. They can be switched from one carb to the other and still fit. Just that the cutaway will not be in the proper position. That doesn't sound like what is wrong here though. Sounds like you might need to do a leakdown test. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.