single PJ questions

[walnut]

Just bought a trinity single carb set up witha Keihin PJ 34 carb I looked for post on here and found some info but most was on the PWK 35. Its used (ebay) The number on the side is a PJ 68RACJE it has 210 main 60 slow jet and DEJ needle if anyone has or had this set up tell me if its close my mods are: T-5, .20 over, degree key +4, stock cages with boysen reeds, pod filter. Just rebuilt, stock carbs jetted at 310 main 27.5 pilot vitos needle clip at bottom. I'm at 850 ele. should I sell the pj and get a pwk? or can this carb work the same. Thanks for any input.

 

[Bansh-eman]

the jetting for the PJ and PWK should be the same. maybe a TINY bit differant. You can get a PJ to run well but they are harder to jet and harder to get to idle then pwk's just toy with it and see if you like it, if not then try a pwk later on.

[Snopczynski]

Well I dont mess with pj's, but if they are close to a pwk jetting wise..... You can try the dej, but do like a 185 main jet, 48-50 pilot with the air screw 2 turns out to start.

[walnut]

Thanks for the replys I need new o rings and I ll give it a shot if any one has a 33 or 35 pwk they want to get rid of let me know how much!

[xXBlessedWithDeathXx]

Just bought a trinity single carb set up witha Keihin PJ 34 carb I looked for post on here and found some info but most was on the PWK 35. Its used (ebay) The number on the side is a PJ 68RACJE it has 210 main 60 slow jet and DEJ needle if anyone has or had this set up tell me if its close my mods are: T-5, .20 over, degree key +4, stock cages with boysen reeds, pod filter. Just rebuilt, stock carbs jetted at 310 main 27.5 pilot vitos needle clip at bottom. I'm at 850 ele. should I sell the pj and get a pwk? or can this carb work the same. Thanks for any input.

 

 

310 main is way to big. my ele is 1300 and i run a 160 main.

[xXBlessedWithDeathXx]

210 main is to big. my ele is 1300 and i run a 160 main.

Edited October 19, 2007 by xXBlessedWithDeathXx