THE358BANSH Posted September 20, 2007 Report Posted September 20, 2007 First off I received my long rod stroker crank from HotRods today and I am very excited! It has been awhile since I took it apart but I think I may be missing a crank seal. All of the crank bearings have a small o-ring in the outer race except for the clutch side output shaft. The bearing is machined for the seal but does not have one. What gives? Since I don't want to run a stroker plate, I think I will go the route of a new port with stroker domes. Considering the fact that I need a new head, do any companys sell CoolHeads with pre-cut stroker domes? Thanks in advance Quote
Bansh-eman Posted September 20, 2007 Report Posted September 20, 2007 are you talking about the small thin c shaped spacers? there should only be 3 halfs... one for tranny one for each side of the crank.. you dont need two one one side... just one half... as for the dome yea they have a ton of them pre cut but if you want to get your squish right your going to need to send them the thinkness of your base gasket and your deck hieght....then they can get it close...you ca ru pre cuts you just run the possibility of lossing some power if your squish is too big... Quote
spike Posted September 20, 2007 Report Posted September 20, 2007 he' talking about the fact that on a hot rod crank there is o-rings on every bearing but the pto side, where the circlip (like he said ^!) goes, you will need to get a new crankshaft circlip if you got rid of the old one. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.