jetting and pilot size for 30mm oko's

[thesheerider]

What size main jet and pilot screw should i get for running two 30mm oko's in the shee?

The shee has a 2 in 1 dyno prt pipe, airbox w/ lid, 20 over on each cylinder.

Im 500 ft above sea level.

 

Any Ideas?? help is definitally needed.

 

oh yea and i was running 220's in the stockies before i changed the carbs.

 

oko's and kehins are basically the same right?

Edited July 20, 2007 by thesheerider

[thesheerider]

couple other questions. should i change the needle or any other jets in the carbs. the carbs were bought as a stock 30mm oko carb. and im only running 120 for compression.