Shrek360 Posted July 17, 2007 Report Posted July 17, 2007 does anyone know if you where to have engine failure and needed to bore a cub or super cub cylinder is it possible? in other words can they be bored and replted? if so how many mm over can they support. Quote
No Limit Powersports Posted July 17, 2007 Report Posted July 17, 2007 does anyone know if you where to have engine failure and needed to bore a cub or super cub cylinder is it possible? in other words can they be bored and replted?if so how many mm over can they support. There are several plating companies that can do cub cylinders. We use millenium and they weld and repair any cylinder damage so the cylinders always come back the same bore size, nice cause they never wear out lol. Quote
Shrek360 Posted July 18, 2007 Author Report Posted July 18, 2007 so you can only get it replated...? it cannot be bored..? Quote
dajogejr Posted July 18, 2007 Report Posted July 18, 2007 I don't think there is enough wall....YOu could bore it and have a sleeve put in, but that's a waste IMO. Stripped and plated....that's the way to go if the nikasil is trashed. Quote
No Limit Powersports Posted July 18, 2007 Report Posted July 18, 2007 Depending on the bore/stroke combination you get some of them have a little room in them but not much and theres little to no gain to be had by doing so. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.