plug chop pics

[DEPUTY DOG]

http://img524.imageshack.us/my.php?image=1000478qm8.jpg

http://img524.imageshack.us/my.php?image=1000478qm8.jpg

 

i have a 87 motor bored .050 with wiesco pistons toomey t-5's lid removed 300 mains and stock needle in stock position and stock pilot about 2 turns out the start is a bit sluggish in 1st but after that you better hold on i was wondering if i should richen the needle or up the mains and any input would be great oh i'm at sea level 80-100 degrees thanks

 

Noah

[DEPUTY DOG]

the dark spot on the left plug was from grease

[DEPUTY DOG]

No one ?????????????????????????? looking for some advice thanks

[fastrthnu]

Holy Mutha F`n crap, someone actually did it right! :ohmy:

 

look a lil lean, want em a tad darker

 

oh, and T5`s have no bottom end, get a timing plate to advance 4-5 degrees. :thumbsup:

[MILO]

assuming you did a WOT plug chop the way it should be done, i'd say it's a bit lean, but you're really close. you need to gradually up your mains a step at a time. a lot of guys think i'm nuts, but it took 370's in mine to get the plug chops to look good. every shee is a little different bud, give her what shee likes.

[DEPUTY DOG]

assuming you did a WOT plug chop the way it should be done, i'd say it's a bit lean, but you're really close. you need to gradually up your mains a step at a time. a lot of guys think i'm nuts, but it took 370's in mine to get the plug chops to look good. every shee is a little different bud, give her what shee likes.

 

thanks i think i will move my clip for my needle one on the rich side and try another chop (wich are a pain in the ass with no bench vice if still lean i have some 320's and let yall know what happens

 

Noah

[XxMeltIcexX]

thanks i think i will move my clip for my needle one on the rich side and try another chop (wich are a pain in the ass with no bench vice if still lean i have some 320's and let yall know what happens

 

Noah

 

THe needle wont affect WOT