AustinONeal Posted June 7, 2007 Report Posted June 7, 2007 i over filled my bansheew with oil and now it load up on low rpms and wont idle, drained the oil turned it on its side, cleaned carbs everything i even took it apart where the seal is and the piece seats well and it look as if it would seal. and the sell isnt old at all i just rebuilt the whole thing bottom end and top and never had any trouble put all new seals in and everything. so is the seal out or is there somthing else i need to know. Quote
chevrolet banshee Posted June 7, 2007 Report Posted June 7, 2007 wen you put oil in it and drive around for a wile dos it have less oil in it and dos it smoke alot Quote
dajogejr Posted June 7, 2007 Report Posted June 7, 2007 Either the crank seal on the clutch side is bad or the case halves aren't sealed. No tranny oil should get into the crankcase, period....even with a good seal. It would just blow out the vent on the back of the cases... Check to make sure the vent isn't plugged... Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.