G-force axle install

[OnlyA2Stroke]

I just tried installing a new G-force axle from RM-ATV. I followed the shee instructions/picture and it still doesn't measure the same length on each side of the axle from the middle of the swingarm carrier. They are almost 3/8" off from the center. What pieces did you guys use out of the kit? I received axle, (3) c-clips, (2) spacers: 1 small(diameter), 1 large(diameter), 3 piece axle nut (allen bolt, outer axle nut, inner axle nut), 4 hub/wheel spacers, 2 thick ones and 2 thin ones.

 

Now which of these pieces do I use and when I followed another link in here it was short on the right side(from the rear of the atv). Do I put a spacer on the right side to make the tire/wheel stick out futher?

 

 

Thanks

[jlsparky7]

You dont need the smaller spacer. Ill take some pics and put them up tomorrow. I had a PITA time putting my axle on too.

 

P.S. Make sure you install new bearings when you do the new axle, just to save you time and headache later on.

[Hollister_Hitman]

here you go:

http://www.bansheehq.com/forums/index.php?...347&hl=axle

[jlsparky7]

here you go:

http://www.bansheehq.com/forums/index.php?...347&hl=axle

 

Beat me to it.