Anybody want to do an RZ conversion?

[Matt96shee]

Hey guys,

I figured I'd offer this up here before I try eBag. For anyone wanting to try an RZ conversion here's almost all the parts you'd need! Not pictured are the stator and flywheel but they are included too. I ended up with all these parts as extras. You'll need a CDI. They pop up on ebay from time to time OR you can go with RDDREAMS like 421stroker's bike. The only thing else is the guts of the servo pulley on the on the jug which is about $50 from a dealer. The jugs are on the stock bore and have never been ported. The pistons show a lot of blowby so you'll atleast need a hone, most likely a clean-up bore. All the elctronics are off an '84 bike as is the stator and flywheel so wiring shouldn't be much of a problem. The topic has been covered here a few times.

 

 

 

 

 

 

 

Again, nothing is wrong with these parts. I collected them while piecing together the whole RZ setup. In fact, I'd rather use these electronics but I bought a complete wiring harness with controllers that was on a banshee.

 

I'm thinking $600 shipped?

[DILUSI]

do you have exhaust flanges from this motor?

[sheerider1026]

i heard these are bad ass.. anyone run one?? i have a bottom end with hot rods crank and tranny, also have 2 sets of unported cylinders, one is stock bore other is 20 over with pistons, all bores in excellent shape.. interested in rades?? i am not real savvy on the rz setup but have heard it is bad ass.. send me a pm if interested