96_banshee_96 Posted February 18, 2007 Report Posted February 18, 2007 Ok so I got the cylinders off and the heads now how do I remove the pistons from the crank? How do I tell if the pistons are good or bad same with the cylinders. Also should there be rubber O rings on the pistons? Question about the carbs how do you tell if they are good or bad they seem to have a shit load of globed oil on them like the guy was mixing his gas real rich with the oil or something. If I clean them up real good will they be fine? These might sound like dumb questions but bare with me this is my first banshee and she needs some work so im going to be asking alot of questions. Quote
mybadbanshee Posted February 18, 2007 Report Posted February 18, 2007 there are little circlips that hold the pistons to the rod.you can barley see them.use a 90 degree pick and pop them out.they will probably go flying across your garage so have so new ones on hand.as for your carbs clean them real well and they should be fine just replace the gaskets when your done.also if you dont have a clymer manual,GET ONE!!it will answer 95% of your questions. Quote
bansheefreak Posted February 18, 2007 Report Posted February 18, 2007 i say get a clymer manual ... too cus if you think pistons have rubber orings you need to be studing the book alot.. we can help alot but sometimes its nice to have a book handy .. Quote
moneybags Posted February 18, 2007 Report Posted February 18, 2007 (edited) Stuff a rag down by the crank so the circlip dose not go in to the bottom end. Wile removing them or putting them in. They like to go flying in install and removal process. Edited February 18, 2007 by moneybags Quote
FireHead Posted February 18, 2007 Report Posted February 18, 2007 i say get a clymer manual ... too cus if you think pistons have rubber orings you need to be studing the book alot.. we can help alot but sometimes its nice to have a book handy .. Ditto :thumbsup: Quote
96_banshee_96 Posted February 18, 2007 Author Report Posted February 18, 2007 (edited) Were do I get the manual? Edited February 18, 2007 by 96_banshee_96 Quote
bansheefreak Posted February 18, 2007 Report Posted February 18, 2007 search ebay or go to local stealership and buy one.. Quote
dajogejr Posted February 18, 2007 Report Posted February 18, 2007 http://www.farmandsandtoys.com/partdetail.asp?partid=172 Quote
mybadbanshee Posted February 18, 2007 Report Posted February 18, 2007 Stuff a rag down by the crank so the circlip dose not go in to the bottom end. Wile removing them or putting them in. They like to go flying in install and removal process. oh yeah i forgot to mention that Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.